Power LEDs as Tesla One-Wire or Common Ground Two-Wire
Super Efficient, Wide Voltage Input LED driverUses batteries or wall adapters!
Over 100 continuous hours using a single D cell or 30 hours from a single AA. Design will operate on input voltages less than 1V!
This LED driver kit allows easy lighting on artwork, scale models and more! Easy to use - power in / power out. Can be used to Illuminate a string of LEDs wired in series (up to 15) with no noticeable decrease in light emission or parallel (up to 20) or Tesla One-Wire fashion (up to 30 SuperBrights) with 1.5V -12V power sources! Small footprint converter can be built into your work.
This is a great converter to incorporate into your solar lighting designs where you are using a solar cell which outputs 1.0 volt! This converter will step it up to to a useful voltage and light up to 15 Super-Bright LEDs! ( Up to 30 SuperBrights when wired as Tesla One-Wire fashion) Depending on your design you may use the same converter to charge batteries for future storage! As long as your battery has 0.8 Volt or more you can use it! Why waste that energy!
See the review here on --->
Startship Modeler
Includes:
Detailed instructions
(1) LEDC1512WND- Pulse switched DC/DC converter
|
LEDC1512WND
|
Size |
14mm x 12mm x 8mm |
Weight |
8g |
Input |
1.0/2.4V - (2.5V-12V wResistor) @150mA Max. DC
|
Output |
~6-50V@100-150mA Pulses |
Consumption |
5-25mA |
LED Specs: |
Super-Bright, Ultra-Bright, Mega-Bright, Hyper |




Shed some light the easy and efficient way!